Bus wraps and ads have to follow the following criteria:

Requirements

Open

Standard Bus Layout

• The Texture needs to be a 24- or 32-bit .tga texture on a scale of Power of 2 (1024x1024 2048x2048, 4096x4096 etc.)

• The Texture needs to follow a set UV layout that is largely the same for most Buses. The Reference images can be downloaded for testing.

• The "Driver Side" is layed out upside down to facilitate a seamless blend between the driver side, the top and the door side. (see sample below for reference)

• Not all busses are able to use the area seamlessly, so take into account that there may be some cutoffs on some buses.

• Bendy Buses use the exact same layout and thus may have overlapping parts, in such cases a second texture should be provided for both parts to avoid this sort of duplication.

Transparency

Open

Double Decker Layout

• The Texture supports Alpha Masking to make the bus Wrap see through in some areas and opaque in others

  • However, it is recommended to avoid gradients and half tones and instead use full tones and dithering to achieve transition effect.

Resolution and Cropping

• Due to the way the UVs are layouted the Front and rear may have a slightly higher spatial resolution than the sides

• Details towards the bottom of the two side areas may be cut off, to compensate for stretching that would otherwise occur. (see sample below for reference)